How to correctly handle the rusty cold wire drawing

Actually cold wire drawing application range is very wide, and cold wire drawing before leaving the factory will be has been specially treated to prevent rusting process, few have some process is not good, so the effect is not very good, if you choose to such products should be how to do, how should we deal with it, as an experienced manufacturer in here for everybody simple introduce correctly handle the knowledge rusty cold wire drawing.

First of all, we should try to clean the surface of the cold wire drawing processing, processing to the back of the processing after clean. After clean, in order to keep the cold wire drawing original state does not change, on the surface of cold wire drawing can use some cleaning detergent, forbids the use of soap and water are being used as a cleaner.

Secondly, after using cleaner clean, at this point you can wipe clean the surface of cold wire drawing, of course, also want to wipe dry, avoid again by oxidation, after drying should pack the goods immediately. Cold wire drawing after wrapping can to transport it.

And cold wire drawing prestressed is also very important, this is mainly due to the construction industry due to too high to the requirement of the wire strength. For prestressed concrete structure, a lot of people are not familiar with, its form mainly by single or into a beam of steel wire, steel wire or steel. Directly bonded prestressed concrete with bond is very concrete, or after the tension by grouting and concrete bonding prestressed reinforcement.

Above is what we summarize some of the cold wire drawing for everyone some rust removal and other related knowledge, but we are here to remind you that the choose and buy the cold wire drawing, or should I keep cold wire drawing, so that we can very good avoid rusty, can amount to avoid the loss of some don't.